Packing; 100g/tube, blister package ,20blister /inner box, 120blister/outer carton :also could make 12 blister per inner carton ,144 blisters per outer carton
Shanghai, Guangzhou, Shenzhen, Ningbo, Qingdao
1 - 5000
5001 - 15000
To be negotiated
Forsen RTV silicone gasket maker
is a one part RTV silicone that remains flexible and withstands high vibration. Designed
primarily for flange sealing with excellent oil resistance on rigid flange sealing, for example on transmissions and cast metal housings.
Forms a high-quality gasket that seals the space between matched parts to prevent leakage of automotive fluids and gases.
It meets manufacturers’ specifications for original equipment.
Seals joined parts in automotive systems - prevents leakage of antifreeze, air, oil and transmission fluid
Meets manufacturers' warranty requirements
Resists oil better than other silicone gasket makers
Won't interfere with sensors
Tack-free cure (time required to dry past tacky state): 30 minutes
Full cure (time required to reach full set): 24 hours
Temperature range (endurance limits of the gasket maker): -75 F to 625 F
Ideal gap-filling capacity (gap sizes in which gasket maker performs best): 0.001" to 0.125"
Maximum gap-filling capacity (maximum gap size between joined parts): 0.240"
Applications:Valve covers, oil pans, timing covers, water pumps and thermostat housings
Applied as a gel to just one surface of the parts to be joined, silicone gasket maker forms a seal between them, keeping out contaminants. Silicone gasket maker resists oil and shop fluids, vibration, heat, and flexing of parts, replacing many conventional gaskets. Parts joined by this silicone gasket maker can easily be removed. The old gasket material comes off effortlessly, simplifying future disassembly and reassembly.
This product is OEM specified: It is approved to meet specifications of original equipment manufacturers.
Directions for use:
1. For best performance bond surfaces should be clean and free from grease.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after theproduct is dispensed.
3. The bond should be allowed to cure (e.g. seven days), before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.
As Supplied – tested at 23°C±2°C, RH50%±5%:
Specific Gravity: 1.15~1.25
Skinning Time, min: 5~15
Application Temperature, °C: +5 to +40
Drop Degree, MM: ≤1
Extrusion Ability, mL/Min: ≥ 300
As Supplied – tested at 23°C±2°C, RH50%±5% 7 days :